As opposed to a sit-down unit, the stand-up lift truck model is completely different to operate. The way at which you pick up loads and your movements are really different. If you do not have proper training for utilizing a stand-up unit, you can probably cause harm to yourself or to co-employees. When using a stand-up model, you should follow the proper safety regulations. There are a few basic operating standards which must be met when utilizing a stand-up unit.
To start on a stand-up unit forklift, it is vital to get a good feel for the steering knob and the controls. As opposed to a steering wheel, the steering is handled with the knob steering plate. Take note that this specific knob moves very fast, thus, you have to be accustomed to moving it carefully in order to be certain not to over steer. The horn is situated on the control handle, like with the control for the movement of the forks and for forwards, backwards. The floor pedal allows the forklift power to move.
Turn the key to start the forklift's engine when you are set to begin. The forks must be retracted at this stage. When you are moving all-over the floor, the forks must be pointed a little upwards. Do not drive with extended forks. If you are traveling forwards, move the control handle forward and to make the lift move forward, step on the pedal. If you are backing up, be sure to beep your horn to alert people around you. Look behind you before stepping on the pedal in order to make sure the way is clear and safe. Then, pull the control handle towards you while stepping on the pedal. Stay alert and focused and make sure that you are operating in a safe manner at all times.
When approaching a corner with the lift truck, turn the steering knob in the direction you are heading. Make sure to keep your foot on the accelerator and keep your hands on the control handle. When turning right, the steering knob would move in a clockwise direction during forward travel. If you are turning left, your steering knob would go in a counter-clockwise direction.
The stand-up models take some getting used to, particularly if you have only operated sit down units. With some training and taking some time to figure out the machine, you could handle loads quickly and efficiently in little time.